UPS and stabilizer supply in Bhosari MIDC
One of the older MIDC estates in the district and one of our denser service areas — forging, fabrication and auto-component units, most of them running presses and compressors that start direct-on-line. — TODO: replace with two named installations and a photograph before launch.
- Bhosari MIDC A, B, C, D, E, F and G blocks
- T-Block and J-Block
- Telco Road and MIDC Road
- Alandi Road and Nashik Phata
- Landewadi, Dighi and Bhosari Gaon
- Moshi and Chikhali, on the Chakan side
Same-day attendance for load-down calls; 4-hour target for AMC customers
What we supply and service in Bhosari MIDC
Bhosari MIDC — questions we get asked
Anything not covered here, call us — most of it is faster to answer on the phone.
What is the most common power problem in Bhosari MIDC?
Voltage sag during shift hours rather than outright outages. The estate is dense with presses, forging hammers and compressors starting direct-on-line, and each start pulls the shared feeder down for a second or two. Controllers reset, drives fault, and the fault log gives no useful clue. A week of logging at the incoming panel usually identifies it, and a servo stabilizer fixes it far more cheaply than a UPS.
Do I need a balanced or unbalanced stabilizer here?
Measure all three phases across a working day first. Bhosari units typically carry a lot of single-phase load spread unevenly across the three, which leaves one phase sitting low. A balanced stabilizer corrects on the average and leaves that phase low, so an independent-phase unit is usually the right specification. Getting this wrong is the most common and most expensive error we correct.
How quickly can you attend a breakdown in Bhosari?
Same day for a load-down call, with a four-hour target for AMC customers. It is about 28 km from the works, so a morning call is normally attended the same afternoon.
Nearby areas we cover
Distances are from our Dhayari works, nearest first. Response times differ with the run, and each page says plainly what we will hold to.